How To Install A Kohler Cast Iron Sink

Having a cast atomic number 26 sink is a thing of dazzler, thanks to its designer await. It is also potent and durable, and unlike stainless steel information technology comes in many colors, making information technology suitable for the bath besides as the kitchen. This article shows how to install one. Since sinks are heavy, lifting the cast iron sink into place can be a tough task. Become a friend to help you.

Step i - Measure out the Sink

Use the template that came with the cast iron sink to make the proper cutout in the counter. If there isn't a template, measure the sink and create one from scratch. Make sure the counter is suitable to bear the weight of the sink.

Stride 2 - Install Handbasket Strainer

It is best to install the basket strainer and faucet earlier installing the sink. Mount the handbasket strainer first. Remove dust and debris from the drain hole with a clammy cloth in order to ensure a practiced seal. Use a generous amount of plumber's putty underneath the basket and push it into place.

From under the sink, put the large rubber washer over the exposed thread followed by a second thinner washer (all this volition have come up with the basket strainer). Screw the large metal nut onto the thread. As it becomes fully tightened the putty volition ooze out, which will demand to be cleaned immediately with a cloth.

Next, the faucet will demand to exist installed by following the manufacturer's instructions in order to comply with the manufacturer'southward terms and atmospheric condition. The installation process varies for each brand.

Step iii - Install Cast Iron Sink

To install the cast iron sink turn information technology upside down while protecting its height surface from damage (as well protect the sink and handbasket strainer if they have already been installed). Clasp some silicone sealant around the edge of the sink and ease the sink into the cutout in a centered position until information technology is in contact with the counter.

Brainstorm the procedure of removing the excess sealant to consummate the installation. In one case the excess sealant has been removed allow information technology to fully dry—one full 24-hour interval should be sufficient. Excess sealant is difficult to take off if not removed before it dries.

Step 4 - Connect the Sink to the Plumbing

Side by side, connect the cast iron sink to the pipes and drain. Connect the bleed tailpiece to the basket strainer. Use the pipage cutter to trim the ends of the hot and common cold pipes. Join them to the faucet using the manufacturer'south instructions.

Footstep 5 - Check Faucet and Drain Connections

Turn on the master water supply and open up the faucet shut-off valves. Check carefully for leaks. If there are any, you may have to retighten everything you installed. Unremarkably, little more than a quarter plow is needed. The cast iron sink project is at present complete.